During the electrical test, I verified that the wiper motors were functional on both the half speed and full speed setting. It was also...

Two Wing Mirrors and one Rear View Mirror to fit. The Wing Mirrors are supplied as standard OEM units with their own mounting arm. This...

With the electrical test successfully completed the Fuse Box could be fitted. The Fuse Box has a long flange which slides under the...

The new Rear Light units are attached to the Rear Wings using a plastic moulded block which ensure the lights are positioned...

I haven't even finished the build yet, and have started upgrading. The handbrake handle has always been a disappointment for me....

The Rear Wings required a lot of work (in comparison to my expectations). The first task was to open up the spacing for the Radius Arm. A...

After fitting the bulkhead carpet, the harness bolt holes were covered and needed to be cleared using a scalpel. The Harness shoulder...

Carpeting the Transmission Tunnel and rear bulkhead was very straight forward. The carpet pieces fitted perfectly and were easy to put in...

Having fitted the carpet around the Fuel Filler Cover, it was then possible to fit the Washer Bottle. There are a couple of options -...

At first site the number and variety of shapes of carpets supplied was bewildering. However, as soon as you realise that all the...

The design of the Knee Panels have recently changed and are reported to be much easier to fit than previous designs. The left hand Knee...

With the Front Wings fully prepared with IVA trim fitted, Repeaters fitted and a mouse cable installed in the Wingstay, it was now time...

Two tasks to prepare the Front Wings before they are fitted to the Wing Stays are to (1) modify the Wings to fit the Repeater lights and...

The Speed Sensor is a sensor that is mounted on the left hand hub and connected to the loom with an Econoseal connector. The sensor is an...

I celebrated a "big" Birthday during the week of the Engine Start and was given the most incredible cake! Huge thanks to Spangles Cakes :...

Without question, the most exciting and tense moment of the build so far. Nervous of potential leaks, another final round of checks was...

The Handbrake lever was previously fitted and the cables routed around the LSD. Now that the brakes had been bled, the Handbrake Cable...

In preparation for Clutch and Brake bleeding, I had previously measured the bleed nipples with vernier callipers in order to find the...

Looking ahead to the point where the engine could be started, it was going to be important to have the exhaust system (and therefore the...

A task that was left over from the installation of the Collector was to connect the Lambda Sensor to the main loom. The key task is to...